Norton/Assa Abloy 6000 Series Low Energy Operator

General Specifications

Door Controls (interior)(exterior) swinging door(s) shall be of rack and pinion design contained within a precision cast aluminum housing.Door closing force shall be adjustable to ensure adequate closing control. Door closing speed shall be controlled by independent hydraulicadjustment valves in the sweep and latch range of the closing cycle. Door Operator shall provide conventional door closer opening andclosing forces unless the power operator motor is activated. Door Operator opening force and speed shall be adjustable in the inverter/interface module’s LCD screen to ensure adequate opening control per accessibility codes. Door Operator shall have an adjustablehydraulic back-check valve to cushion the door speed if opened violently. Door Operator shall utilize the inverter/interface module’s LCDscreen and joystick to establish door closes and open positions. [(Door Operator shall be AUTOMATICALLY ACTIVATED by either a slightpush or pull in the direction of opening swing – Push and Go.) (Door Operator shall be SELECTIVELY ACTIVATED by external initiatingdevice, i.e. wall switch, etc.) (Door Operator shall be both AUTOMATICALLY ACTIVATED and SELECTIVELY ACTIVATED.)] Unit shallinclude “E-saver” feature to automatically recognize abled body traffic and immediately trigger door to close after sensing no forces ondoor. Unit shall have delay for motor activation, electric lock interfacing, and hold open time. Units shall have SPDT relay for interfacinglatch retraction exit devices or similar products and have 24VDC @ 1.3A output for connection of electric strike, lock, radio frequencyreceiver, etc. Units shall have Vestibule sequencing input for operation of two or more units. Unit shall have smoke ventilation inputs topower open doors when activated by fire or smoke alarm. Unit shall have a three-position Selector Mode Switch that will permit the unit tobe switched “ON” to monitor for function inputs, switched to “H/O” for indefinite hold open function or switched “OFF” which will disablefunction inputs allowing unit to be used as a manual door closer. Unit shall be ETL tested to UL standards for automatic closing door. TheUnit shall be adjustable to provide compliance with the requirements of the Americans With Disabilities Act (ADA). Unit shall be certified byBHMA to meet ANSI A117.1 and A156.19 requirements. Unit shall meet UL, cUL, UL10C and UL10B standards.

2 year limited warranty.

Additional Specifications for Functions

For Power Operator Function:When activated, the unit shall, by means of a motor, chain and closer, power open the door at both a speed and force that are adjustableto accessibility codes. The door shall be powered from a door closed position to a full door open position and remain in momentary holdopen for 5 seconds minimum (adjustable 0 to 30 seconds in 1 second increments). [(Unit shall power open door to full open position up to110°.) (Unit shall be capable of opening door manually from 110° – 180°.)] Once unit reaches full hold open position, if reinitiated, unit’smomentary hold open time shall restart from the maximum set time. If unit is initiated during the closing cycle, unit shall revert to openingcycle beginning at that door position. Unit shall have a toggled hold open input that upon first initiation will power door to a maintainedhold open position; a second initiation will allow door to close. Unit shall have obstruction detection on closing, which will reverse theclosing door to the full open position then re-attempt to close door after momentary hold open time has elapsed. Obstruction detection onopening shall shut motor off, allowing door to close under spring force. These obstruction detection features shall be integral to unit. Duringclosing cycle, the unit shall close door under full spring power not to exceed a closing force of 15 lbf.